[. . . ] Your 360° Complete is provided with a special cord set with an integrated Safety Extra Low Voltage power supply. In order to avoid any leakage of the cleaning fluid, place the Clean&RenewTM station on a flat, stable surface. Do not tip, move suddenly or transport the station in any way if a cleaning cartridge is installed. [. . . ] Also, if the shaver is taken out prematurely and is not dry, its electronics could be harmed. When the program is finished, the blue «clean» light will shine. You can release the shaver by pushing the «start cleaning» button. If the shaver is locked into the Clean&RenewTM station, push the «start cleaning» button (2) to release the shaver and take it out. Switch positions off = (switch is locked) Press and push up the switch to operate the shaver: on = Shaving with the pivoting head (the pivoting cutting system automatically adjusts to every contour of your face). Fix = Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e. We recommend that you shave before washing, as the skin tends to be slightly swollen after washing. ⷠTo maintain 100% shaving performance, replace your foil and cutter block, when the replacement light (18) comes on (after about 18 months), or when worn. Shaving with the cord If the shaver is completely discharged and you do not have the time to recharge in the Clean&RenewTM station, you may also shave with the shaver connected to the mains via the special cord set. Automatic cleaning After each shave, return the shaver to the Clean&RenewTM station and proceed as described above in the section «Before shaving». With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles. The hygienic cleaning solution cartridge contains alcohol which, once opened, will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks. Quick cleaning Press the foil release buttons (12) to lift the shaver foil (do not remove the foil completely). Thorough manual cleaning Manual cleaning is recommended only when the Clean&RenewTM station is not available, e. However, do not clean the shaver foil nor the cutter block with the brush as this may damage them. [. . . ] After you have replaced the shaving parts (foil and cutter block), use a ball-pen to push the reset button (19) for at least 3 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. If later on, the charging light comes on again, this indicates that the shaver is being recharged to maintain its full capacity. [. . . ]